Installing the blade, Installing the blade -27, All models – Craftsman 113.248510 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ALL MODELS
INSTALLING THE BLADE
WARNING: TO AVOID INJURY FROM ACCIDENTAL
STARTING, MAKE SURE THE POWER CORD IS
UNPLUGGED BEFORE REMOVING ANY PART
FROM THE SAW.
1 - Remove the blade guard by loosening the two (2)
mounting screws with a phillips screwdriver and
lifting the blade guard upward.
2. Loosen the upper blade guide assembly and
lower to approximately 3 inches above reartable
and retighten lock knob. This is necessary to
make adjustments to blade guide and back up
roller bearing.
3. Loosen the two capscrews that lock the upper
blade guides using a 1/8-inch hex “L" wrench
and separate them about 1/8-inch. Repeat the
same step for the lower blade guides.
26