Craftsman 113.248510 - Manual (Page 18)

MODELS 113.248320,
113.248440, and
113.248510
4. Locate the correct motor pulley {Model 113.248210
has a “one-step” pulley). Placethe shaft key into the
groove on the motor shaft. Align the groove in the
pulley with the shaft key and install the motor pulley
on the motor shaft with the setscrew boss toward the
motor.
ALL MODELS
5. Place the Poly “V” belt into the motor mount as
shown on the underside of the band saw.
6. Look at the motor mount and find the slot that is nar­
rower than the other three. When mounting the
motor, the motor stud without aspacer goes into this
slot.
SLOT
7. Carefully position the motor so that the poly “V” belt
is around the motor pulley and the four motor studs
align with the slots in the motor mount.
8. Push motor studs through and install the flanged
lock nuts to the three (3) motor studs with spacers.
Start the flanged nuts by hand only at this time.
MOTOR MOUNT
мотов MOUNT
9. Install the threaded stud through the hole in the
lower leg of the motor mount and over the motor stud
as shown.
18