Craftsman 113.248510 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. Loosen the setscrew which locksthe blade guide
support and push the support all the way back.
Repeat for lower blade guide support.
UPPER BLADE
GUIDE SUPPORT
SETSCREW
5. Loosen the setscrew which locks the upper back
up bearing and push the bearing all the way
back. Repeat procedure for lower back up bear
ing.
UPPER BACKUP
BEARING SETSCREV\
WARNING: TO AVOID SERIOUS EYE INJURY OR
SCRAPES IF THE BLADE SHOULD SUDDENLY
UNCOIL, WEAR SAFETY GOGGLES. CAREFULLY
U N C O I L T H E B L A D E H O L D I N G I T A T A R M S
LENGTH.
6. Uncoil the blade.
7. Place the blade over the wheels with the teeth
pointing downwards toward the table as shown.
Make sure the blade is between the blade guides
and is in the center of the rubber tires.
NOTE: If the blade wiM not reach around both
wheels, lowerthe upper wheel by turning the tension
knob counterclockwise.
27