Self-timer photography – Canon EOS 650 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. Self-timer Photography
The self-timer allows you to delay shutter release
3)
for ten seconds.
To set:
4
)
1) Put the camera on a table, tripod, or other flat
surface.
2) Set the main switch to either “A” or “(<•>).”
Open the switch cover and press the blue film
winding mode selector (see p. 26).
Turn the electronic input dial until “C^” mark
appears in the display panel.
58
5) Focus the subject in either the ONE SHOT or
SERVO mode.
6) Make sure the exposure is correct and then
press the shutter button. The self-timer opera
tion indicator will start blinking and the frame
counter displays the countdown.
•
The shutter automatically releases ten
seconds after being pressed. Two seconds
before shutter release, the indicator starts
blinking faster.
• To cancel the self-timer before shutter
release, press the battery check button.
•
Do not stand in front of the camera when
you press the shutter button.
If your eye will not be at the viewfinder when
you press the shutter button, cover the
viewfinder as shown to prevent stray light from
entering at the rear, using the viewfinder cover
attached to the neckstrap shoulder ¡Dad.
59