Canon EOS 650 - Manual (Page 7)

11*1
2. Loiding the Battery
This camera uses one, six-volt lithium battery pack (2CR5).
1) Remove the grip with a coin or
similar object.
When replacing the battery,
first push the orange lever up­
ward to remove the dead bat­
tery.
When using a tripod, dismount
the camera before replacing
the battery.
3)
'1
As shown in the photo, load the
battery so that its terminals
face in the direction of the
camera. Make sure the battery
is pushed in all the way until it
is locked by the orange lever.
Replace the grip securely.
3^ Chec^ the Battery
1) Set the main switch to the
green “O”, “A” or “((•))” mark.
The display will come on at this
time. If the display does not ap­
pear, confirm that the battery is
loaded correctly.
(example)
2) Open the switch cover on the
back of the camera and press
. the battery check button(a).
Battery power shows in the
display panel.
n_-f1 Iri _ f1
1 1
Battery power Have a new
sufficient battery handy
(blinking) (no battery
check mark)
be p-.
□ Q □ d
'
1
Replace with new battery
• When "be” blinks, see P. 73.
In temperatures about 20°C/68°F