Assign bussed signal names dialog, 18 assign bussed signal names dialog – Achronix ACE Version 5.0 User Manual
Page 210
Dialogs
Chapter 3. Concepts
Assign Bussed Signal Names Dialog
The Assign Bussed Signal Names Dialog wizard allows the user to combine multiple signals from the
”Monitor Channels” table into a bus. After configuring the bus in the dialog, the
bus name and indices are propagated to all the selected signals, changing the signal names appropriately.
The bus/signal names will then be used in the SnapShot sampled output, visible in the
See also:
Figure 3.109: Assign Bussed Signal Names Dialog
Assign Bussed Signal Names Dialog Options
Option
Description
Signal Name
The desired name of the bus.
Width
The width (in bits) of the bus. This is not editable. It will reflect the number of
signals which were selected from the ”Moniter Channels” table.
Starting Index
The desired starting index of the bus, sometimes also called the offset into the
bus.
Ascending Order
When selected, the bus indices will start at Starting Index and will increment
Width
times.
Descending Order
When selected, the bus indices will start at Starting Index and will decrement
Width
times.
Finish
This button will accept the specified bus configuration, close the dialog, and
apply the changes to the
”Monitor Channels” table.
Cancel
This button will discard the specified bus configuration and close the dialog.
No changes will be applied to the
”Monitor
Channels” table.
UG001 Rev. 5.0 - 5th December 2012
198