Revision history, Version 5.0.0 – Achronix ACE Version 5.0 User Manual
Page 385
Chapter 6. Revision History
Revision History
The following outline lists the revision history of this document.
Version 5.0.0:
• Updated to match ACE 5.0 functionality additions and changes:
–
Name Changes:
* ”Physical Layout” was renamed ”Floorplanner”
· ”Physical Layout perspective” was renamed
· ”Physical Layout view” was renamed
* the ”ChipTap” Debugger was renamed the ”SnapShot” Debugger
· ”Chiptap Debugger view” was renamed
(with associated
buttons too)
·
run chiptap
was renamed
· ACX CHIP TAP macro was renamed ACX SNAP SHOT
· support files renamed (
snapshot.log
,
snapshot.vcd
,
*.snapshot
debugger config
files)
* Device/Package name changes and separation
· The ACE ”Target Device” (option
partname
) was previously a combination of the device
and package as a single unified selection. The package selection is now separated from
the target device, as individual
, and is selectable from the
· ”22iHD1000-FBGA2280” was renamed ”AC22iHD1000”.
· ”22iHP360-FBGA1520” was renamed ”AC22iHP360”.
· Note:
this also affected all IP Configuration Editors which had device-specific
behaviors/parameters.
–
22i IP Configuration Editors
* added new
* added new
* added new
* added new
LRAM FIFO Configuration Editor
* updated
to support the separation of read width/write width
* updated
Advanced PLL Configuration Editor
to expose sbus ports and use new device
names
* updated
to mention how lanes may now be disabled.
* updated
* updated
PCI Express Configuration Editor’s Overview Page
with a new field to configure
the number of DMA channels to be used for the interface.
* updated
Interlaken Configuration Editor
–
Added description of
–
Added support for Placement Regions and Placement Region Constraints
* Added task describing the use of
Placement Regions and Placement Region Constraints
* Added the new
* Added the
Create Placement Region Dialog
* Added the
* Updated the
for the new Placement Region tool.
* Updated the
, adding checkbox for Region Constraints
373
UG001 Rev. 5.0 - 5th December 2012