Achronix Speedster22i Snapshot - Manual (Page 13)

Snapshot GUI in ACE
The following procedures describe how to invoke the Snapshot view in ACE.
1. Open the ACE GUI tool as shown in Figure 5.
Figure 5: ACE Tool
After programming the Achronix FPGA successfully, user will be ready to use the “Snapshot
Debugger” tool. To go to the Snapshot Debugger tool, the user needs to click on the
“Snapshot Debugger” tab from the upper left side. Then the user will see the Snapshot
Debugger window as shown in Figure 6.
2. The following figure depicts the GUI of the Snapshot Debugger tool.
UG016, September 22, 2014 13