Catler KM 8011 - Manual (Page 14)

14
ASSEMBLY & OPERATION
ATTACHING MIXING AND WHISKING
TOOLS
1. Raise the motor head by pressing the
RELEASE button.
2. Align the groove in the top of the mixing
attachment with the locking pin on the
spindle extending down from the mixer
motor head.
3. Push the attachment upwards and turn
clockwise until it locks securely onto the
locking pin on the spindle (see picture
below).
4. Lower the mixer motor head by pressing
the RELEASE button and gently lowering
the mixer motor head until it locks into
the closed position.
5. The splash guard can now be assembled
if required. Slide the main ring into
position on top of bowl, then assemble
the pour spout.
OPERATING THE MIXER
Planetary mixing action
By replicating a similar mixing action used
by commercial mixers in bakeries and
patisseries, the Scraper Mixer Pro head
rotates around the bowl while rotating the
beater in the opposite direction. This ensures
a superior and thorough mixing result
without the need for a rotating bowl.
1. Ensure the speed control dial is set to the
OFF position, plug the cord into a 220–
240V power outlet and switch the power
ON at the power outlet. The illuminated
LED speed indicator band will fl ash and
the count up/down timer will display
0:00. The mixer is now ready.
2. Add ingredients to the mixing bowl as
indicated in the recipe.
3. Always begin mixing by selecting a low
speed setting on the speed control dial.
Starting on a low speed will prevent
ingredients splattering. Increase the
speed as suited to the mixing task. The
speed setting can be adjusted during
operation. If necessary, stop the mixer
during operation and scrape any food
mixture down the sides of the mixing
bowl with a spatula.
4. If the mixer has not been used for 5
minutes it will automatically change from
STANDBY mode to a power saving OFF
mode and the illuminated LED will switch
off . To exit OFF mode and begin mixing,
turn the dial to the selected speed or
press one of the count up/down timer
buttons.
5. Do not turn the mixer on with the scraper
beater in place if the mixing bowl is
empty. This will cause the scraper beater
to make a loud noise as it scrapes the
bowl.