Catler KM 8011 - Manual (Page 15)

15
ASSEMBLY & OPERATION
6. When ingredients are in the mixing bowl,
the scraper beater may make a slight
noise as it scrapes the sides and bottom
of the bowl. This is normal and should
not cause concern.
COUNT-UP TIMER
The count-up timer is for gauging mixing
time. You can monitor the time it takes to
thoroughly mix the ingredients, so that the
next time you mix the same ingredients you
can set the count-down timer for the specifi c
time.
The count-up timer will automatically begin
counting up as soon as the dial is rotated
from OFF to one of the speeds.
When the dial is turned to PAUSE the total
time will be displayed on the LCD and will
fl ash. When the dial is turned to OFF, the LCD
display will reset back to 0:00.
COUNT-DOWN TIMER
The count-down timer is for any recipe that
specifi es the length of time ingredients
should be mixed. For example, if a recipe
reads, “beat for 3 minutes”.
To set the count-down timer, press the up or
down arrows until the desired mixing time is
displayed on the LCD screen. Press and hold
to scroll more quickly.
Rotate the dial to select the desired speed,
and begin mixing. When the timer has
fi nished counting down, it will beep. The
motor will automatically turn off and the
timer will fl ash OFF.
The control dial must to be rotated to the
OFF position to reset the timer and to
continue mixing.
The maximum time displayed on the timer
is 60 minutes. The mixer will automatically
switch OFF at 60 minutes. The control dial
needs to be rotated to the OFF position to
reset the timer and to continue mixing.
PAUSE MODE
While mixing, at any stage, you can rotate
the control dial to the PAUSE setting. This
will suspend the timer, and turn the motor
off . This enables you to assess the mixing
progress or add additional ingredients
without aff ecting the timer.
For example, if you are mixing using the
count-up timer mode, you can rotate the
control dial from one of the mixing speeds
to PAUSE. The mixer motor will stop and the
timer will pause.
Once ready, rotate the dial back to one of the
mixing speeds and the timer will continue to
count-up from the exact time it was paused.
Alternatively, if the mixer is on PAUSE, you
can reset the timer to 0:00 by rotating the
dial to OFF.
The PAUSE function can also be used in
the count-down timer mode. To continue
mixing, rotate the dial back into one of the
mixing speeds to allow the timer to continue
counting down.