BoonDocker POLARIS: 2011-14 PRO RMK 800 Intercooled - Manual (Page 3)

Revised 10/22/2014 Page 3 of ?
www.boondockers.com………………..... ……….………………....877-522-7805
7. Use a punch to remove the steel center from
necessary rivets. Use a straight edge to mark the
cut line to remove lower portion of kick plate.
Leave the upper portion for side panel mounting.
8. Remove the stock exhaust deflector and seal. Install
exhaust block off plate using supplied rivets from the
top using plate as rivet backer.
9. Use the attached template to locate muffler hole
location, Center punch and then drill 2 1/2” hole for
exhaust outlet.
10. Remove front suspension bolts and install tunnel
support plates, Re-install suspension bolts and finish
securing using supplied rivets..
11.Install spring tab and heat deflector on belt
drive models using factory bolts as shown.
12. Using a pair of pliers break off chassis tab in
the image and grind to match the stock con-
toured surface. (Not necessary to remove for
Tial exhaust system)