BoonDocker POLARIS: 2011-14 PRO RMK 800 Intercooled - Manual (Page 9)

Revised 10/22/2014 Page 9 of ?
www.boondockers.com………………..... ……….………………....877-522-7805
43. Zip tie factory ECU plug so there is proper
clearance with out wire chaffing or rubbing. 44. Install Torque building silicone air box,
make sure not to slide on to far for proper jack-
shaft clearance. Tighten hose clamps.
NOTE: if installing inner-cooler see next step.
45. Install silicone hose onto throttle body adapt-
ers make sure to have proper jackshaft clearance
IF NOT installing inner-cooler go to step#49
46.Install Torque building inner-cooler, (Tech
tip, moving steering post may make install eas-
ier.) Adjust for clearance of head, electrical wir-
ing, fuel filter, fan, and chassis before tighten-
47Locate the A/C PWR plug, (A/C plug is lo-
cated in Velcro pouch above the fan near steer-
ing post. Plug the fan booster into the factory A/
C plug, and rubber connector into fan.
48.Install the fan onto the inner-cooler using the
supplied 1/4” bolts and lock washers. Route the
fan power to fan booster and secure w/ zip ties.