Clarion VXZ758R - Manual (Page 14)

14
VXZ758R
280-8178-00
English 7. OPERATIONS
Basic Operations
Note: Be sure to read this chapter referring to the front diagrams
of chapter “2. CONTROLS” on page 5 (unfold).
CAUTION
Be sure to lower the volume before switching
off the unit power or the ignition key. The unit
remembers its last volume setting. If you
switch the power off with the volume up,
when you switch the power back on, the
sudden loud volume may hurt your hearing
and damage the unit.
System check and speaker
setting
During the initial power up of this unit, it will go
through a system check procedure.
This procedure verifies any devices connected
through CeNET. Any additional CeNET devices
plugged into the unit after the initial power up will
initiate the system check procedure.
When the power is turned on, “SYSTEM CHK”
appears in the display if the wire connections
were modified.
The system check starts automatically within the
unit.
When the system check is complete, “SP-
SETTING” appears in the display. Perform the
speaker setting.
1. Turn the [ROTARY] knob to select the
speaker system.
∗ The factory default setting is “2ch”.
(Adjustment 2ch/5.1ch)
2. Press the [ ] button.
∗ The setting is complete and the display
switches to the radio mode.
Turning on/off the power
Note:
• Be careful about using this unit for a long time
without running the engine. If you drain the car’s
battery too far, you may not be able to start the
engine and this can reduce the service life of the
battery.
1. Press the [SRC] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [SRC] button for 1 second
or longer to turn off the power for the unit.
Selecting a mode
1. Press the [SRC] button to change the
operation source mode.
2. Each time you press the [SRC] button, the
operation mode changes in the following
order:
Radio mode ➜ DAB mode ➜ DVD mode ➜
CD changer mode ➜ TV mode ➜ AUX
mode ➜ Radio mode...
∗ External equipment not connected with
CeNET is not displayed.
Adjusting the volume
Turn the [ROTARY] knob to adjust the volume.
∗ The volume level is from 0 (minimum) to 33
(maximum).
Switching the display
●When the power is turned on
Each time you press the [DISP] button, the
display switches in the following order:
Main display ➜ Clock display ➜
Main display ...
∗ Once selected, the preferred display becomes
the display default. When a function
adjustment such as volume is made, the
screen will momentarily switch to that
function’s display, then revert back to the
preferred display several seconds after the
adjustment.
CT (Clock Time) function
The CT function receives CT data sent from an
RDS station and displays the time. Press the
[DISP] button to switch to the CT display.
∗ If a CT data is not being received, “––:––CT” ap-
pears in the display.
Note:
• CT data is not transmitted in some countries and
by some broadcast stations. Also, in some areas,
the CT may not display accurately.
Setting the Z-Enhancer Plus
This unit is provided with 4 types of sound tone
effects stored in memory. Select the one you
prefer.
∗ This function cannot be adjusted when as follows:
“Pro Logic” is set to “ON”, the speaker system
is set to “5.1ch”, DVD/DTS-CD is being played.
+VXZ758R_01-09-Eng.p65 05.3.1, 6:02 PM 14