Cisco 340 - Manual (Page 17)

5-17
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-08
Chapter 5 Configuring the Client Adapter
Setting Advanced Infrastructure Parameters
Go to the next section to set additional parameters or click OK to return to the Profile Manager screen.
On the Profile Manager screen, click OK or Apply to save your changes.
Enable Radio Management
Support Checking this check box enables the access point to which the client
adapter is associated to control the use of radio management (RM),
provided RM is enabled on the access point. RM is a system-wide
feature that involves multiple infrastructure nodes. The RM feature on
the access point acts on radio measurement requests from other
network devices to instruct the access point and its associated clients
to perform required radio measurements and then report them.
Default: Checked
Note This parameter is available in Install Wizard version 1.2 or
later for 350 series cards and Install Wizard version 1.3 or
later for CB20A cards.
Note Access points must use Cisco IOS Release 12.2(13)JA or later
to enable RM. Refer to the documentation for your access
point for instructions on enabling this feature.
Table 5-4 Advanced (Infrastructure) Parameters (continued)
Parameter Description