Cisco 340 - Manual (Page 32)

5-32
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-08
Chapter 5 Configuring the Client Adapter
Setting Network Security Parameters
EAP-TLS authentication
If using ACU to
configure card Enable Host Based EAP (802.1x)
and Dynamic WEP in ACU and
select Enable network access
control using IEEE 802.1X (or
Enable IEEE 802.1x authentication
for this network) and Certificates
(or Smart Card or other Certificate)
as the EAP Type in Windows Set up and enable WEP and enable
Open Authentication for the SSID
and specify the use of EAP
If using Windows XP
to configure card Select Enable network access
control using IEEE 802.1X and
Smart Card or other Certificate as
the EAP Type Set up and enable WEP and enable
Open Authentication for the SSID
and specify the use of EAP
EAP-TLS authentication with WPA
If using ACU to
configure card Enable Wi-Fi Protected Access
(WPA), Host Based EAP (WPA),
and Dynamic WEP in ACU and
enable WPA and select Enable
network access control using IEEE
802.1X and Certificates (or Smart
Card or Other Certificate) as the
EAP Type in Windows Select a cipher suite that includes
TKIP; set up and enable WEP; and
enable WPA and Open
Authentication for the SSID and
specify the use of EAP
Note To allow both WPA and
non-WPA clients to use the
SSID, enable optional
WPA.
If using Windows XP
to configure card Enable WPA and select Enable
network access control using IEEE
802.1X and Smart Card or other
Certificate as the EAP Type Select a cipher suite that includes
TKIP; set up and enable WEP; and
enable WPA and Open
Authentication for the SSID and
specify the use of EAP
Note To allow both WPA and
non-WPA clients to use the
SSID, enable optional
WPA.
PEAP authentication
If using ACU to
configure card Enable Host Based EAP (802.1x)
and Dynamic WEP in ACU and
select Enable network access
control using IEEE 802.1X (or
Enable IEEE 802.1x authentication
for this network) and PEAP as the
EAP Type in Windows Set up and enable WEP and enable
Open Authentication for the SSID
and specify the use of EAP
If using Windows XP
to configure card Select Enable network access
control using IEEE 802.1X and
PEAP as the EAP Type Set up and enable WEP and enable
Open Authentication for the SSID
and specify the use of EAP
Table 5-6 Client and Access Point Security Settings (continued)
Security Feature Client Setting Access Point Setting