Hybrid Racing HR 06+ 8th Gen Civic Si Shifter Cables - Manual (Page 13)

13
Install Guide
STEP 18:
Next we need to move back under the
car to install the mounting plate back
to the bottom of the car. Slide the plate
back on the studs and using a 10mm
socket put the (2) nuts on to hold it in
place. Before tightening these nuts
make sure the rubber seal is aligned
with the plate correctly as illustrated
(you should NOT see any rubber be-
ing squeezed out of the sides).
STEP 19:
Next we need to install the bracket I
said to hold on to in step 4. First slide
the cables onto the bracket but do not
close the bracket or put the clamping
bolt in. First using a 10mm socket put
the (2) M6 bolts in the bracket and
tighten it to the car. Next, adjust the
cables as needed around the exhaust
and install the M6 clamping bolt with a
10mm boxed-end wrench and tighten
as illustrated.
Fig 18
Fig 20
Fig 19
STEP 20:
Finally, using your 10mm socket re-
install the heat shield with the (4) M6
bolts and (2) nuts and your installation
is complete!