Hybrid Racing HR 06+ 8th Gen Civic Si Shifter Cables User Manual
Page 8
8
Install Guide
STEP 10:
With the assembly out on, we can now
swap the springs. This step is much easi-
er if you have an another person helping
you. The gear selector is under spring
pressure so start by holding it back with
your hand then using your 12mm boxed
end wrench to remove the M8 bolt as il-
lustrated in Fig 10A. Once the bolt is out,
carefully slide the gear selector off, mak-
ing sure to keep all the parts in order.
With the selector off you can now swap
the large and small springs with the ones
provided in the kit (IMPORTANT: make
sure not to lose the washer shown with
red arrow touching the smaller spring in
Fig 10B as it must go back on where it
was after swapping the springs for proper
operation of the transmission gear selec-
tor). Now that the new springs are in-
stalled, slide the gear selector back on
making sure it is on the same way it was
when it came off. If you happen to get the
pieces out of order, the order they go in is
displayed in Fig 10C.
Fig 10B
Fig 10A
Fig 10C