Hybrid Racing HR 06+ 8th Gen Civic Si Shifter Cables - Manual (Page 4)

4
STEP 4:
Once you have removed the heat shield, you
will need to remove the (2) mounting brack-
ets and the mounting plate using a 10mm
socket. For the front bracket remove the (2)
M6 bolts( Fig 4A). For the middle bracket, re-
move the (2) nuts (Fig 4B), for now, the
brackets may be left attached to the cables.
Before removing the mounting plate, mark
the orientation of the plate with a sharpie.
Then remove it by removing the (2) nuts and
sliding the plate off the studs (Fig 4C).
OEM Cable Removal
Fig 4A
Fig 3B
Fig 3A
STEP 3:
Next you will need to remove the heat shield for the exhaust Using a 10mm socket or nut driver, re-
move the (4) M6 bolts and (2) nuts pictured and rotate the heat shield out from behind the exhaust
(Fig 3A/3B). Depending on your exhaust set up, removal of a catalytic converter or midpipe may be
required to gain access to this heat shield.
Fig 4B
Fig 4C