Kontron VMP2 - Manual (Page 61)

VMP2 Configuration
ID 24855, Rev. 02 Page 4 - 9 © 2002 PEP Modular Computers GmbH
4.3.3 Onboard Device Addresses
Figure 4-3: VMP2 Device Address Map
  Note:
• For write access to this address area (0xFFE0 0000-0xFFFF
FFFF), it is only possible to use byte-wide write commands.
• When the memory expansion socket is used for NVSRAM, byte
0xFFF0 0000 (J1 installed) or byte 0xFFF8 0000 (J1 removed)
is reserved for the output of post codes to the VMP1-Post. Data
should not be stored at either of these locations.
UART A
UART B
Onboard Register
+
Onboard Register
+
UART B
UART A
reserved reserved
Socket
Socket
soldered FLASH,
(512k page)
soldered FLASH,
(512k page)
Reset Entry
Boot jumper J1 installed Boot jumper J1 removed
0xFFF8 0000
0xFFF0 0000
0xFFE8 0000
0xFFE0 0010
0xFFE0 0008
0xFFE0 0000
0xFFF8 0000
0xFFF0 0000
0xFFE8 0000
0xFFE0 0010
0xFFE0 0008
0xFFE0 0000
0xFFFF 0100