Kontron AM4022 uEFI BIOS - Manual (Page 52)

The uEFI Shell AM4022 uEFI BIOS
Page 46 ID 1052-1333, Rev. 1.0
OPTIONS: Sata0Speed Indicates maximum speed supported by SATA port 0
(AMC port 2)
Sata1Speed Indicates maximum speed supported by SATA port 1
(AMC port 3)
Sata2Speed Indicates maximum speed supported by SATA port 2
(I/O extension)
Sata4Speed Indicates maximum speed supported by SATA port 4
(AMC port 12)
Available parameters for above SATA options:
Gen1 (SATA 1.5 Gb/s),
Gen2 (SATA 3.0 Gb/s),
Gen3 (SATA 6.0 Gb/s)
Sata0Hotplug: Enable hotplug for SATA port 0 (AMC port 2)
Sata1Hotplug: Enable hotplug for SATA port 1 (AMC port 3)
Sata2Hotplug: Enable hotplug for SATA port 2 (I/O extension)
Sata4Hotplug: Enable hotplug for SATA port 4 (AMC port 12)
WrProtSata: Used to select onboard SATA flash write protection
If enabled, the onboard SATA flash is write-protected
after POST. OS needs to be prepared to work with
write-protected flash. For further information, refer to
the operating system’s documentation.
WARNING: CONTACT KONTRON BEFORE
USING THIS FUNCTION!!!
WrProtEeprom: Used to select onboard system EEPROM write
protection
If enabled, the system EEPROM is write-protected
after POST.
WrProtSpi Used to select onboard SPI boot flash write
protection
If enabled, both of the onboard SPI boot flashes are
write-protected after POST.
kboardconfig (continued)