Kontron KISS 1U PCI 762 - Manual (Page 17)

7. Product Description KISS 1U_SBC_762 – User's Guide (Version 1.00)
You can easily convert your system to a desktop version. Unscrew the left and right hand 19" brackets from the device.
2 1
4 Screws for attaching the 19" bracket
3 Holes for rack mounting
2 KISS 1U platform chassis
1 19" bracket with handle
4
3
Fig. 9: Detail - 19" bracket with mounting screws
There are rubber feet (refer to the chapter 6 “Scope of Delivery” supplied, if you want to convert your KISS 1U to a desktop
unit. To attach the rubber feet (included), please follow the instructions in the section 8.1 “Attaching the Rubber Feet”.
7.1.1. Controls and Indicators
1
2
3
1 Power button
2 Power LED
3 Hard disk LED
Fig. 10: Power button on the front
The power button (Fig. 10, pos. 1) is located at the front side of the platform, behind the front access panel
(Fig. 7, pos. 4) and allows to power ON/OFF the system. Please observe the settings option for “Restore on AC Power Loss”
in the BIOS Setup. Setting options: Power On/Power Off/Last State.
Power LED
(green) This LED (Fig. 10, pos. 2) lights up green when the system is switched on using the power button.
Please observe the Warning below!
Prerequisite:
The system must be connected to an appropriate power source (AC).
HDD LED
(yellow) This LED (Fig. 10, pos. 3) lights up yellow at HDD/SSD activity.
Do not press the eject button, while the drive LED is lit or flashing.
Warning!
Turning the power off using the power button (refer to Fig. 10 pos. 1) does not disconnect the
KISS 1U platform from the AC power source.
AC wide range PSU: Please observe that the ON/OFF switch (Fig. 15, pos. 8) of the AC wide range PSU
(Fig. 17) does not disconnect the KISS 1U from the AC power source. Even you turn off the system using
the power button Fig. 8, pos. 7), and the ON/OFF switch of the PSU, there is still a standby-voltage of
5 VSb on the SBC (refer also to the hint in the subsection 7.2.2).
www.kontron.com 15