Ports on the front side, Filter mat and filter mat holder, External accessible drive bays – Kontron KISS 1U PCI 762 User Manual
Page 18: System fans installed in fan slide-in modules
7. Product Description
KISS 1U_SBC_762 – User's Guide (Version 1.00)
7.1.2. Ports on the Front Side
7.1.2.1.
USB Ports
The KISS 1U system has four USB (2.0) interfaces (see Fig. 8, pos. 4 and pos. 5) on the front side. Various USB-compatible
peripherals can be connected to these ports.
Fig. 11: USB interfaces on the front side (SBC card)
Fig. 12: USB interfaces on the front side (backplane)
If USB devices are connected to the USB ports on the front of the device, the front access panel can not
be closed and locked.
7.1.2.2.
LAN Interface
This interface is available as (Fig. 8, pos. 6) RJ45 connector and supports a data transfer rate up to 10/100/1000Mbps.
7.1.3. Filter Mat and Filter Mat Holder
The filter mat (Fig. 30) and the filter mat holders (Fig. 31, Fig. 8, pos. 9) are located behind the air grilles of the front
access panel (Fig. 7, pos. 2 and pos. 4) and over the vent openings of the chassis front panel (Fig. 29, pos. 5). The filter
mat holders are fastened to the chassis front panel (Fig. 8, pos. 10 and Fig. 28, pos. 1) by knurled screws Fig. 28, pos. 3).
The filter mats are inserted into the filter mat holders. These filter mats protect your system against dust and dirt (refer to
the subsection 10.2 “Cleaning the Filter Mat”).
7.1.4. External accessible Drive Bays
Two front-accessible drive bays, D1 (1x 5.25" Slim) and D2 (1x 3.5"), are located on the front side, which are equipped
according to the ordered system configuration.
Fig. 13: Configuration example with a DVD Slim drive (D1)
and with no drive installed in the 3.5" drive bay (D2)
Fig. 14: Configuration example with a DVD Slim drive (D1)
and a Raid1 slim drive for
2x 2.5" SATA HDD/SSD (D2)
7.1.5. System Fans installed in Fan Slide-in Modules
The four system fans are integrated in user-friendly, replaceable fan slide-in modules (refer to the subsection7.5 “Fan
Slide-in Modules”). The fan slide-in module (Fig. 8, pos. 9) can be replaced as described in the subsection 10.1
“Replacing the System Fans”.
16
www.kontron.com