Kontron KISS 1U PCI 762 - Manual (Page 26)

8. Installation and Removal KISS 1U_SBC_762 – User's Guide (Version 1.00)
8.
Installation and Removal
8.1. Attaching the Rubber Feet
If the system is to be used as a desktop version, the rubber feet supplied with the device can be attached to it.
To attach the rubber feet (included, refer to chapter 6 “Scope of Delivery”), proceed as follows:
Before attaching the rubber feet, ensure that your system is switched off and disconnected from the
main power source.
Ensure that all components are securely installed and that the device cover has been screwed on tightly.
1. Turn the device upside down on a table or desk.
2. Remove the protective film from the rubber feet.
3. Stick the four rubber feet to the underside of the device.
24 www.kontron.com