Kontron KISS 1U PCI 762 - Manual (Page 31)

10. Maintenance and Prevention KISS 1U_SBC_762 – User's Guide (Version 1.00)
10.
Maintenance and Prevention
Kontron Europe systems only require minimal maintenance and care to keep them operating correctly.
‰ Occasionally wipe the system with a soft dry cloth.
‰ Remove persistent dirt by use of a soft, slightly damp cloth (only use a mild detergent).
‰ Clean the air filter mat regularly (refer to the section 10.2 “Cleaning the Filter Mat”).
10.1. Replacing the System Fans
The operation of the KISS 1U platform is permitted only with a functional fan slide-in module.
Defective components may be replaced only by Kontron original spare parts.
‰
part number of the fan slide-in module: 1017-2548
Please refer to the ESD safety procedures for handling assemblies with static sensitive devices.
Failure to take heed of this warning instruction can result in damage to the device.
Important instructions!
The fan slide-in module can be replaced during operation. This should only be carried out by a qualified
specialist, who is aware of the associated dangers.
Keep your hands and fingers away from rotating parts of the fan. Before taking out the fan slide-in
module, wait until the fan has totally stopped.
To replace the fan slide-in module, proceed as follows:
1. Open the device, as described in the subsection 8.2.1 “Installing /Removing Expansion Cards” (steps 2-3). Pull the
cover back as far as necessary to gain access to the fan slide-in module.
2.
Unplug the corresponding power cable (Fig. 23, pos. 2) of the defective fan.
3. Loosen the captive knurled screws (Fig. 23, pos. 1) and pull the fan slide-in module upwards out of the fan
compartment (Fig. 23, pos. 4).
4. Replace the fan slide-in module with a new functioning one and push the latter into the system fan compartment until
it is attached to the connector.
5. Tighten the knurled screws up again.
6. Close the device and secure the cover with the knurled screws.
When closing the cover, pay attention that the cover fixing brackets (Fig. 24, pos. 2 and pos. 4) slide into
the corresponding retaining brackets (Fig. 20, pos. 5) of the chassis.
www.kontron.com 29