Kontron KISS 2U KTQ87 - Manual (Page 34)

8. Installation and Removal KISS 2U V2_MB_SBC – User's Guide (Version 1.00)
8.3.1.2.
Installing /Removing Low-Profile Expansion Cards into 2U V2 with Motherboard
For KISS 2U V2 system configuration with motherboard for low-profile expansion cards, is not necessary
to remove the card cage, when installing the expansion cards.
To install or remove low profile expansion card in system configuration with motherboard proceed as follows:
1. Open the system as described in the subsection 8.3.1.1 (step 1-4).
2. Unscrew the fastening screws of the slot bracket or card slot bracket (Fig. 23, pos. 6). Retain the screws for later use.
3. Insert/remove the expansion card/s in respectively out from the expansion slot/s of the motherboard and fix them, or
the slot bracket/s to the rear of the card cage.
4. Close the system and secure the cover with the knurled screws as described in the section 8.2 “Cover”.
32 www.kontron.com