Chassis, Fig. 28: removing the cover – Kontron KISS 2U KTQ87 User Manual
Page 33
8. Installation and Removal
KISS 2U V2 MB_SBC– User's Guide (Version 1.00)
3.
Pull the cover out a little bit (Fig. 27) to release the cover centering and fixing brackets (Fig. 24, pos.3 and pos. 4)
from the retaining plate of the chassis (see Fig. 21, Fig. 22, pos. 1) on the front side. At the same time the centring
latches and the cover retaining plates (Fig. 21, Fig. 22, pos. 7 and 8) on the rear side will be removed from the fixing
bracket and centring slots of the cover (Fig. 24, pos.5 and 6).
Fig. 27: This movment allow you to remove the centring and fixing bracket of the cover from the retaining plate of the chassis
4.
Lift the cover up (on the rear edge) and remove it (Fig. 28).
Fig. 28: Removing the cover
The motherboard with the corresponding riser card (not in configuration for low-profile cards), respectively the SBC card
with the corresponding butterfly-backplane are mounted on a card cage.
The card cage must be pulled-out a little bit from the chassis, in order to have access to the fastening screws of the slot
bracket or expansion card slot bracket (Fig. 29).
For KISS 2U V2 systems with SBC, unscrew the three screws (Fig. 21, pos. 11) and the four screws on the rear side (
5.
Fig. 13 and Fig. 15, pos. 4). Retain the screws for later use.
6.
For KISS 2U V2 systems with motherboard (not in configuration for low-profile cards), unscrew the four screws
(Fig. 22, pos. 11) and the four screws on the rear side (Fig. 15, pos. 4). Retain the screws for later use.
7.
Lift the card cage a little upwards, and slide it a little bit out.
Fig. 29: Pulled-out card cage for configurations with SBC and motherboard, but not for configurations with motherboard for low profile
cards (shownas a KISS 2U V2 system configuration with SBC)
8.
Close the device and secure the cover with the knurled screws.
9.
Insert/remove the expansion card/s in respectively out from the expansion slot/s of the motherboard, the riser card
or butterfly backplanes and fix them, or the slot bracket/s to the rear of the card cage (see details of Fig. 29).
10.
Close the system and secure the cover with the knurled screws as described in the section 8.2 “Cover”.
www.kontron.com
31