Kontron M2M Smart Services Developer Kit User Manual - Manual (Page 16)

16
2.3 Antennas
There are 2 antennas for 802.11 (WLAN) and 802.15.4 (WPAN) connectivity in each Kontron M2M Smart Services
Developer Kit. If your kit also supports 3G connectivity there are an additional 2 smaller antennas for 3G connectivity.
WARNING: The antennas supplied with the kit are the only antennas approved to be used with the device. Use of
any other antennas will void the regulatory approvals.
2.4 Power Supply
WARNING: The power supply included with the Kontron M2M Smart Services Developer Kit is 100-240 Vac, 50/60
Hz input, 12 Vdc, 2A output. A. No other power supply should be used beyond what has been provided with the kit.
Use the appropriate cord for your geography. Any IEC320-C7 power cord with appropriate safety agency rating is
acceptable for use, but do not use the IEC320-C7-PW cords that are squared on one side.
Figure 13 shows the power supply and power cords supplied with the M2M System.
Figure 10. M2M System power supply and power cords
2.5 System Cooling
The system is passively cooled. There are no system fans. It is important that the M2M System have adequate
ventilation so be careful when mounting the system to not block the vents on the label side of the system.
2.6 Processor and Memory
Processor
The M2M System in the Kontron M2M Smart Services Developer Kit board accommodates either a Intel® Atom®
E620 (600MHz) or a Intel® Atom® E640T (1.0GHz) processor. For high volume M2M system production, other
processor options are possible.