10 re-installing the chassis covers – Kontron M2M Smart Services Developer Kit User Manual User Manual
Page 35
35
5.10 Re-installing the Chassis Covers
Follow this procedure (Using a torque screwdriver (torque spec. 1.5 inch/pound))
1. Position the cover over the open unit so that the mounting brackets align and the top, bottom and side are
aligned and ready for reassembly.
2. Screw the 2 screws in the bottom using a Phillips screw driver.
3. Screw the 2 screws in the top using a Phillips screw driver.
4. Screw the 1 screw on the end using a Phillips screw driver.
5. The finished unit should appear as below; note that the spacer is no longer installed in the M2M System.
Figure 33. The M2M System with the 3G module fully installed and spacer removed
Note: The cover needs to slide
out slightly before lifting off the cover (the connectors extend into the
thickness of the flange)