Kontron CP307-V BIOS - Manual (Page 108)

OEM Feature CP307/CP307-V BIOS Guide
Page 98 ID 35978, Rev. 2.0
P R E L I M I N A R Y
PCI-to-PCI Bridge Reset SDO
This function is used to perform a PCI-to-PCI bridge reset using a software reset mechanism
prior to configuring the PCI devices on the bus behind the PCI-to-PCI bridge.
Optimal and Fail-Safe default settings: Disabled
cPCI Signal to IRQ5
This function allows the system to select which cPCI signal should be routed to IRQ5.
Optimal and Fail-Safe default settings: Disabled
cPCI Signal to NMI
This function allows the system to select which cPCI signal should be routed to NMI.
Note: The cPCI Fail signal cannot be routed to IRQ5 and NMI at the same time. No cPCI
signal can be routed to NMI if the Watchdog is selected to NMI.
Optimal and Fail-Safe default settings: Disabled
SETTING DESCRIPTION
Disabled Use this setting to disable a PCI-to-PCI bridge reset.
Enabled Use this setting to enable a PCI-to-PCI bridge reset.
SETTING DESCRIPTION
Disabled Use this setting to prevent the cPCI signals from being routed to IRQ5.
cPCI DERATE Use this setting to select the cPCI DERATE derate signal to be routed to IRQ5.
cPCI ENUM Use this setting to select the cPCI ENUM derate signal to be routed to IRQ5.
cPCI FAIL Use this setting to select the cPCI FAIL derate signal to be routed to IRQ5.
SETTING DESCRIPTION
Disabled Use this setting to prevent the cPCI signals from being routed to NMI.
cPCI FAIL Use this setting to select the cPCI FAIL derate signal to be routed to NMI.