Replacing the wiper blades, Problems with the windshield wipers, Lights and windshield wipers – Mercedes-Benz E-Cab 2013 Owners Manual User Manual

Page 135: Windshield wipers

Advertising
background image

3

Å Intermittent wipe, high (rain sensor
set to high sensitivity)

4

° Continuous wipe, slow

5

¯ Continuous wipe, fast

B

í Single wipe/ î To wipe the
windshield using washer fluid

X

Switch on the ignition.

X

Turn the combination switch to the
corresponding position.

In the Ä or Å position, the appropriate
wiping frequency is set automatically
according to the intensity of the rain. In
the Å position, the rain sensor is more
sensitive than in the Ä position, causing
the windshield wipers to wipe more
frequently.

Replacing the wiper blades

Important safety notes

G

WARNING

For safety reasons, switch off the windshield
wipers and remove the SmartKey from the
ignition lock before changing the wiper blades
(vehicles with KEYLESS-GO: make sure that
the on-board electronics are in state

0).

Otherwise, the wiper motor could be switched
on suddenly and cause injury.

!

Never open the hood if a windshield wiper

arm has been folded away from the
windshield.
Never fold a windshield wiper arm without
a wiper blade back onto the windshield.
Hold the windshield wiper arm firmly when
you change the wiper blade. If you release
the windshield wiper arm without a wiper
blade and it falls onto the windshield, the
windshield may be damaged by the force of
the impact.
Mercedes-Benz recommends that you have
the wiper blades changed at a qualified
specialist workshop.

!

To avoid damaging the wiper blades,

make sure that you touch only the wiper
arm of the wiper.

Replacing the wiper blades

Removing the wiper blades

X

Remove the SmartKey from the ignition
lock or turn it to position

0 (KEYLESS-GO).

X

Fold the wiper arm away from the
windshield until it engages.

X

Firmly press release knob : and pull the
wiper blade upwards from the wiper arm in
the direction of the arrow.

Installing the wiper blades

X

Position the new wiper blade in the retainer
on the wiper arm and slide it into place in
the opposite direction to the arrow.
The wiper blade audibly engages.

X

Make sure that wiper blade is seated
correctly.

X

Fold the wiper arm back onto the
windshield.

Problems with the windshield wipers

The windshield wipers are obstructed

X

For safety reasons, you should remove the
SmartKey from the ignition lock.

or

X

Switch off the engine using the Start/Stop
button and open the driver's door.

Windshield wipers

133

Lights and windshield wipers

Z

Advertising
This manual is related to the following products: