Mercedes-Benz G-Class 2010 COMAND Manual - Manual (Page 75)

Selecting a Predefined Category
COMAND first searches for destinations
along the route within the selected category.
COMAND then searches for destinations in
the vicinity of the vehicle's location.
If COMAND is unable to find any destination,
a message to that effect will be displayed.
X Select OK.
X If necessary, select another category.
If COMAND finds destinations, a list is
displayed in the right-hand part of the
screen. Here you will find the stopover
destinations in the selected category,
sorted by distance from the current vehicle
location.
The list shows
R
Name
R
Information on the location of the stopover
destination in relation to the direction of
travel and the
R
Current distance to the stopover
destination.
X To choose a destination: Press 9
or :.
X To select a destination: Press 9.
The Enter Destination menu appears and
displays the address of the destination.
X To cancel a selection: Select Back.
X To start route calculation: Select Start.
Entering Another Destination as
Stopover Destination
X If necessary, switch to navigation mode
and display menu system (
Y page 53).
X Select Destination£Stopover.
X To enter: Select OTHER.
Choose from:
R
Address Entry
R
From Memory
R
From Last Destination
R
From POIs
X Select a menu item.
The rest of the destination entry will vary
depending on the selection made:
For the
Address Entry option see:
Entering a destination via address
(
Y page 62).
For the From Memory option see:
Entering a destination from the destination
memory (
Y page 70).
For the From Last Destination option see:
Entering a destination from the last
destinations (
Y page 71).
For the From POIs option see:
Entering a POI ( Y page 73).
X To start route calculation: Select Start.
Deleting Stopover Destination
An existing stopover destination can be
deleted.
X Switch to navigation mode if necessary.
X Select Destination£Stopover
£Delete Stopover.
COMAND deletes the stopover destination
and recalculates the route to the main
destination.
POI Input
Entering a POI in Local Area of
Destination
i It is only possible to enter a POI in the
local area of the destination when route
guidance is active.
X In the map display with the menu system
displayed, select
Destination£ From
POIs£Near Destination.
X Continue by selecting the POI category
(
Y page 74).
POI Input
73
Navigation
Z