Mercedes-Benz CL-Class 2010 Owners Manual - Manual (Page 125)

Displaying info
X Select Info in map view with the menu
system displayed ( Y page 89).
The route information appears.
Example illustration: Display with main destination
and stopover
:
Distance/estimated time of arrival/
estimated journey time to the stopover
destination
; Stopover destination P
= Street, city and state/province
?
Main destination O
A Distance/estimated time of arrival/
estimated journey time to the main
destination
i COMAND uses the time set in COMAND
as the basis for calculating the estimated
arrival time. The clock must be set correctly
in COMAND (
Y page 79). The arrival time is
displayed in local vehicle time, based on
the time zone set in the vehicle.
The following data cannot be seen until the
route calculation has been completed:
R Distance to destination
R
Estimated arrival time
R
Estimated remaining travel time
If the destination is located within a
partially digitized area, the following data
may differ from the facts:
R
Distance to destination
R
Estimated arrival time
R
Estimated remaining travel time
Displaying route information
X Select Route Q Route Info in map view
with the menu system displayed
(
Y page 89).
The route information appears.
: Information for highlighted portion of
route
;
Highlighted portion of route
= Next portion of route
X Closing route info: Select Back and press
W or press back button % in the center
console (
Y page 75).
X Displaying next or previous route
section: Select Next or Previous.
X Zooming into or out of route: Select N
or M.
Where am I?
You can display your current position while
route guidance is active as well as when route
guidance has been canceled.
COMAND navigation system (during route guidance)
123
Control systems
216_AKB; 3; 90, en-US
d2ureepe,
Version: 2.11.8.1
2009-05-15T11:47:50+02:00 - Seite 123
Z