Comand navigation system (entering a destination), Introduction, Control systems – Mercedes-Benz CL-Class 2010 Owners Manual User Manual
Page 95
X
Select
Navi.
X
Check the check box for menu item
City
(3D).
Setting route type
You can set the following route types:
R
Fast Route: COMAND calculates a route
with minimized driving time.
R
Dynamic Route: COMAND calculates a
route with minimized driving time and takes
into account traffic messages received
along the route. Thus, the navigation
system can dynamically recalculate the
route. Roads that are blocked will be
avoided whenever possible. For
information on traffic messages see
(
R
Short Route: COMAND calculates a route
with minimized route length.
X
Select
Navi Q Mode.
The list of available rote types appears. The
dot # indicates the currently selected
setting.
X
Select route type: Fast Route, Dynamic
Route or Short Route.
X
Exit menu: Slide
X
V
Y
.
i
If you change the route type setting during
active route guidance, COMAND calculates
a new route. If you change the setting when
route guidance is inactive, COMAND uses
the new setting for the next route guidance.
Setting route mode
With this function you can select the following
options for route calculation:
R
Minimize Highways
R
Minimize Toll Roads
R
Minimize Tunnels
R
Minimize Ferries
R
Minimize Motorail Trains
X
Select
Navi Q Mode.
The mode list appears.
X
Switching mode on or off: Select desired
modes.
Depending on the previous status, the
mode is switched on or off. A checkmark
indicates that the mode is switched on. It
is possible to switch on more than one
mode.
X
Exiting menu: Slide
X
V
Y
or press back
button % in the center console
(
COMAND will verify whether it can
incorporate the modes if you select them
with route guidance active.
If possible, COMAND calculates a new
route considering the selected options.
If the route cannot be recalculated with the
selected options, a message appears and
an announcement is made. COMAND
calculates a new route. Only options that
are possible will be considered.
Displaying highway information
When this function is enabled, highway
information ahead will display automatically
(
Audio fadeout
X
Select
Navi Q Audio Fadeout.
When the check box is checked U the
volume of the current audio source fades
during a navigation announcement.
COMAND navigation system
(entering a destination)
For safety reasons, only enter a new
destination when the vehicle is stationary.
COMAND navigation system (entering a destination)
93
Control systems
216_AKB; 3; 90, en-US
d2ureepe,
Version: 2.11.8.1
2009-05-15T11:47:50+02:00 - Seite 93
Z