Replacing bulbs for rear lamps, Replacing wiper blades, Safety notes – Mercedes-Benz CL-Class 2010 Owners Manual User Manual

Page 466: Placing wiper arms in vertical position, Removing wiper blades, Practical hints

Advertising
background image

Replacing bulbs for rear lamps

Tail lamp unit

The tail lamps are equipped with HiP bulbs
and LEDs. Have them replaced at an
authorized Mercedes-Benz Center.

Replacing wiper blades

Safety notes

G

Warning!

For safety reasons, switch off the wipers and
remove the SmartKey from the starter switch
(vehicles with KEYLESS-GO: Make sure the
vehicle’s on-board electronics have status

0)

before replacing a wiper blade. Otherwise, the
wiper motor could suddenly turn on and cause
injury.

G

Warning!

Wiper blades are components that are subject
to wear and tear. Replace the wiper blades
twice a year, preferably in the spring and fall.
Otherwise the windshield will not be wiped
properly. As a result, you may not be able to
observe surrounding traffic conditions and
could cause an accident.

!

To avoid damage to the hood, the wiper

arms should only be folded forward when
in the vertical position.

!

Never open the hood when a wiper arm is

folded forward.
Hold on to the wiper when folding a wiper
arm back. If released, the force of the
impact from the tensioning spring could
crack the windshield.
Do not allow a wiper arm to contact the
windshield glass without a wiper blade
inserted.
Mercedes-Benz recommends that you have
this work carried out at an authorized
Mercedes-Benz Center.

Placing wiper arms in vertical position

Wiper arms in vertical position

X

Make sure the hood is fully closed.

Vehicles with SmartKey

X

Turn the SmartKey in the starter switch to
position

1.

X

Turn the combination switch to wiper
setting °.

X

With wiper arms in vertical position, turn
the SmartKey in the starter switch to
position

0.

X

Remove the SmartKey from the starter
switch.

Vehicles with KEYLESS-GO

X

Make sure the vehicle’s on-board
electronics have status

1.

X

Turn the combination switch to wiper
setting °.

X

Press the KEYLESS-GO start/stop button
repeatedly until the windshield wipers
start.

X

Press the KEYLESS-GO start/stop button
when the wiper arms are in a vertical
position.

Removing wiper blades

!

Do not pull on the wiper blade inserts.

They could tear.

464

Replacing wiper blades

Practical hints

216_AKB; 3; 90, en-US
d2ureepe,

Version: 2.11.8.1

2009-05-15T11:47:50+02:00 - Seite 464

Advertising