Mercedes-Benz C-Class 2008 Owners Manual - Manual (Page 122)

121
Controls in detail
Power windows
̈ Switch on the ignition ( ୴ page 82).
̈ Opening: Press the desired switch 1
to 4 ( ୴ page 120) to the resistance
point.
The corresponding window will move
down until you release the switch.
̈ Closing: Pull the desired switch 1 to
4 ( ୴ page 120) to the resistance
point.
The corresponding window will move
up until you release the switch.
If the window encounters an obstruction
that blocks its path in a circumstance where
you are closing the window by pressing and
holding the switch, by pressing and holding
button ‹ on the SmartKey or SmartKey
with KEYLESS-GO*, by pressing and holding
the sensor surface (vehicles with
KEYLESS-GO*) on an outside door handle,
or by pressing and holding button , on
the climate control panel (Canada only), the
automatic reversal function will not operate.
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you, and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle. A child’s unsupervised ac-
cess to a vehicle could result in an accident
and/or serious personal injury.
i You can also open or close the windows us-
ing the SmartKey, see “Summer opening fea-
ture” (
୴ page 123) and “Convenience closing
feature” ( ୴ page 124).
i Operating the windows from the rear is not
possible if you activate the override switch
(
୴ page 57).
i With the SmartKey in starter switch
position 0 or removed from the starter switch,
the power windows can be operated:
ț until you open the driver’s or front passenger
door
ț for approximately 5 minutes if no door was
opened Warning!
G
If you press and hold the switch up when
closing the window, and upward movement
of the window is blocked by some obstruc-
tion including but not limited to arms, hands,
fingers, etc., the automatic reversal will not
operate. ୴୴