Oldcastle BuildingEnvelope HP-1750 - Manual (Page 30)

30 JULY 2011
H P - 1 7 5 0 I N S T A L L A T I O N M A N U A L
Web Address: www.oldcastlebe.com
Phone: 1-866-OLDCASTLE (653-2278)
SSG - INSTALLING-ANCHORING UNITS
ANCHOR SIZE DETERMINED
BY STRUCTURAL REQUIREMENTS
HP-10435
HP-10343
NOTE:
1) INSTALL FIRST UNIT, PLUMB,
SQUARE AND ANCHOR.
2) ROTATE NEXT UNIT INTO PLACE
AND ANCHOR.
3) REPEAT ACROSS OPENING.
4) ANCHOR BOLTS REQUIRED AT
6" OF EACH SIDE OF MULLION.
5) INSTALL HP-10343 SNAP FILLERS
AFTER UNIT HAS BEEN FULLY
INSTALLED AND ANCHORED.
ANCHOR WITH PIPESLEEVE
REQUIRED FOR LIVELOAD ONLY.
PLACE FRONT HOOK OF
HP-10390 FILLER OVER
LEG OF HP-10469 MULL.
ONCE UNIT IS POSITIONED AS
SHOWN IN DETAIL AT LEFT.
ROTATE AS SHOWN ABOVE
UNTIL FILLER SNAPS INTO
MULLION. THEN SHIM AND
ANCHOR AS SHOWN BELOW.
NHP-10446