Rice Lake AutoLift HE Low-Profile Lift - Manual (Page 5)

Introduction and System Setup 1
About This Manual
This manual is intended for use by service technicians responsible for installing and servicing
RoughDeck HE
AutoLift Option TM low-profile floor scale with pneumatic lifting devices.
This manual can be viewed and downloaded from the Rice Lake Weighing Systems web site at
www.rice-
lake.com
.
1.0 Introduction and System Setup
The RoughDeck ™ HE AutoLift Floor Scale is a fully electronic low profile load receiver constructed of stainless
steel and is designed for harsh washdown environments. The AutoLift is available in 48"  48" and 60"  60" deck
sizes and 2K, 5K, and 10K capacities.
The AutoLift uses four corner-mounted, FM-approved load cells recessed into the frame channels for protection. A
signal-trim summing board for any necessary corner corrections is enclosed in a NEMA Type 4X junction box
mounted outside the scale. All AutoLifts come pre-trimmed. You should not need to make any corner corrections.
You can order AutoLifts with holes drilled in the scale deck directly above each foot for adjusting foot height with
a screwdriver from above. See Section 4.3 on page 13 for replacement part and optional equipment part numbers.
1.1 Safety
Safety Signal Definitions:
Indicates an imminently hazardous situation that, if not avoided, will result in death or serious
injury.
Indicates a potentially hazardous situation that, if not avoided could result in serious injury or
death, and includes hazards that are exposed when guards are removed.
Indicates a potentially hazardous situation that, if not avoided may result in minor or moderate
injury.
Indicates information about procedures that, if not observed, could result in damage to
equipment or corruption to and loss of data.
General Safety
Do not operate or work on this equipment unless you have read and understand instructions in the
manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact
any Rice Lake Weighing Systems dealer for replacement manuals. Proper care is your responsibility.
Failure to heed may result in serious injury or death.
DO NOT allow minors (children) or inexperienced persons to operate this unit.
DO NOT operate without all shields and guards in place.
DO NOT jump on the scale.
DO NOT use for purposes other then weight taking.
DO NOT place fingers into slots or possible pinch points.
DO NOT use any load bearing component that is worn beyond 5% of the original dimension.
DO NOT use this product if any of the components are cracked.
DO NOT exceed the rated load limit of the unit.
DO NOT make alterations or modifications to the unit.
DO NOT remove or obscure warning labels.
Keep hands, feet and loose clothing away from moving parts.
DANGER
WARNING
CAUTION
Important
WARNING