Rice Lake CW-90X Over/Under/Washdown Checkweigher - Ethernet - Manual (Page 18)

14 Ethernet TCP/IP Card Installation Manual
Figure 4-7. Comm Port Properties screen
The WLAN configuration port uses the following settings:
• Baud Rate: 9600
• 8 Bits
• No parity
• 1 Stop Bit
• No Flow Control
5. Make the changes and click OK to save the changes.
6. Reset the WLAN option card by pressing the manual reset button shown in Figure 4-8, and immediately
upon release, enter three lowercase x characters (xxx) at the same time.
Figure 4-8. Manual Reset Button location on WLAN option card
The easiest way to connect is to hold down the x key on the PC’s keyboard until the manual reset button
is released and the PC screen displays the MAC address and software version as shown in Figure 9. This
must be done within three seconds of resetting the WLAN option.
Manual Reset Button
Note