Rice Lake CW-90X Over/Under/Washdown Checkweigher - Ethernet - Manual (Page 24)

20 Ethernet TCP/IP Card Installation Manual
4.10 WiPort Disclaimer
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
• Re-orient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/tv technician for help
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device is intended only for OEM integrators. The OEM integrator should be aware of the following
important issues.
Labeling of the End Product
The label of the end product integrating this module must clearly indicate that the end product contains an FCC
approved RF module. The format of such statement could be Contains Transmitter with FCC ID: R68WIPORTG
or something similar.
RSS-GEN Sections 7.1.4 and 7.1.5 Statement for Devices with Detachable Antennas
This device has been designed to operate with the antennas listed in the certificate, and having a maximum gain
of 5 dB. Antennas not included in this list or having a gain greater than 5 dB are strictly prohibited for use with
this device. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent insotropically radiated power (EIRP) is not more than that required for successful communication.
Integration Note
(a) This module is authorized under limited module approval specified to mobile host equipment. So, the antenna
must be installed such that 20 cm is maintained between the antenna and the user.
(b) The transmitter module may not be co-located with any other transmitter or antenna.
As long as the two conditions above are met, further transmission testing will not be required. However, the
OEM integrator is still responsible for testing their end product for any additional compliance requirements
required with this module installed (for example, digital device emission, PC peripheral requirements, etc).
In the event that these conditions cannot be met (for example) certain laptop configurations, general
purpose PCMCIA or similar card, or location with another transmitter), then the FCC authorization is no
longer considered valid and the FCC ID cannot be used on the final product (including the transmitter)
and obtaining a separate FCC authorization.
Changes or modifications to this device not explicitly approved by Lantronix will void the user’s authority
to operate this device.
Note