Rice Lake CW-90X Over/Under/Washdown Checkweigher - Ethernet - Manual (Page 30)

26 Ethernet TCP/IP Card Installation Manual
Figure 6-2. Sender setup
The parameters are set using a telnet connection within DeviceInstaller. We can see that the only
parameters changed from default (other than baud rate) is the port for the receiver to look for, the
ConnectMode to adjust each for its own function, Listen or Sender, and the Remote IP in the sender to
direct the packet to the correct IP address.
These units, once set up, will do an auto connect as soon as either they return to weigh mode or after a power cycle.
Note