Document Outline

• GENERAL VIEW
• 1 INTRODUCTION
• 2 INSTALLATION
  • 2.1 POWERSCAN® D8330 INTERFACE CABLE CONNECTIONS
  • 2.2 BC-80X0 INTERFACE CABLE CONNECTIONS
  • 2.3 RS-232 CONNECTION
  • 2.4 USB
  • 2.5 IBM USB POS
  • 2.6 WEDGE CONNECTION
  • 2.7 PEN EMULATION CONNECTION
  • 2.8 NETWORK CONNECTIONS
    • 2.8.1 BC-8060 Network Connectors
    • 2.8.2 Network Cabling
    • 2.8.3 Network Termination
  • 2.9 POWERSCAN® M8300 BATTERY MAINTENANCE
    • 2.9.1 Battery Charging
    • 2.9.2 Replacing PowerScan® M8300 Batteries
  • 2.10 MOUNTING THE BC-80X0 / C-8000 CRADLE
    • 2.10.1 Desktop Mounting
      • Portable Desktop Use
      • Fixed Desktop Use
    • 2.10.2 Wall Mounting
• 3 POWERSCAN® M8300 SYSTEM AND NETWORK LAYOUTS
  • 3.1 STAND-ALONE LAYOUTS
    • 3.1.1 Point-to-Point Reader Layout
    • 3.1.2 Stand-Alone Layout with Multiple Readers
    • 3.1.3 Multiple Stand-Alone Layouts
    • 3.1.4 C-BOX Layout
  • 3.2 MULTIDROP STAR-SYSTEM™ NETWORK LAYOUTS
    • 3.2.1 Host Master Layout
    • 3.2.2 BC-8060 Master Layout
    • 3.2.3 Master BC-8060 Network Troubleshooting
• 4 CONFIGURATION
  • 4.1 CONFIGURATION METHODS
    • 4.1.1 Reading Configuration Barcodes
    • 4.1.2 Using Datalogic Aladdin™
    • 4.1.3 Copy Command
    • 4.1.4 Sending Configuration Strings from Host
  • 4.2 SETUP PROCEDURES
  • 4.3 POWERSCAN® D8330 SETUP
  • 4.4 POWERSCAN® M8300/BC-80X0 POINT-TO-POINT SETUP
  • 4.5 POWERSCAN® M8300/BC-80X0 STAND-ALONE SETUP
    • 4.5.1 Using Multiple M-Series Readers with Same Cradle
    • 4.5.2 PowerScan® M8300/STAR-Modem™ in Stand-Alone Mode
  • 4.6 POWERSCAN® M8300/STAR-SYSTEM™ SETUP
  • 4.7 BC-8060 STAR-SYSTEM™ NETWORK SETUP
  • 4.8 INTERFACE SELECTION
  • 4.9 USB READER CONFIGURATION
  • 4.10 CHANGING DEFAULT SETTINGS
• 5 REFERENCES
  • 5.1 RS-232 PARAMETERS
    • 5.1.1 Handshaking
    • 5.1.2 ACK/NACK Protocol
    • 5.1.3 FIFO
    • 5.1.4 RX Timeout
  • 5.2 PEN PARAMETERS
    • 5.2.1 Minimum Output Pulse
    • 5.2.2 Conversion to Code 39 and Code 128
    • 5.2.3 Overflow
    • 5.2.4 Output and Idle Levels
    • 5.2.5 Inter-Block Delay
  • 5.3 NETWORK PARAMETERS
    • 5.3.1 Slave Address Range First/Last
    • 5.3.2 Network Warning Message
    • 5.3.3 Reception Warning Message
    • 5.3.4 Master Header/Terminator Selection
  • 5.4 DATA FORMAT
    • 5.4.1 Header/Terminator Selection
    • 5.4.2 Define Special Key Sequence
    • 5.4.3 Address Stamping
    • 5.4.4 Address Delimiter
    • 5.4.5 Time Stamping Format
    • 5.4.6 Time Stamping Delimiter
  • 5.5 POWER SAVE
    • 5.5.1 Sleep State
    • 5.5.2 Enter Sleep Timeout
  • 5.6 READING PARAMETERS
    • 5.6.1 Trigger Signal
    • 5.6.2 Trigger Click
    • 5.6.3 Trigger-Off Timeout
    • 5.6.4 Reads per Cycle
    • 5.6.5 Safety Time
  • 5.7 DECODING PARAMETERS
    • 5.7.1 Ink-Spread
    • 5.7.2 Overflow Control
    • 5.7.3 Interdigit Control
  • 5.8 ADVANCED FORMATTING
    • 5.8.1 Match Conditions
  • 5.9 RADIO PARAMETERS (M8300 SERIES ONLY)
    • 5.9.1 Radio Protocol Timeout
    • 5.9.2 Radio RX Timeout
    • 5.9.3 Power-Off Timeout
    • 5.9.4 Transmission Mode
    • 5.9.5 Beeper Control for Radio Response
    • 5.9.6 Single Store
    • 5.9.7 Batch Mode
    • 5.9.8 Find Me (PowerScan® M8300 only)
  • 5.10 DISPLAY PARAMETERS (SOME M8300 MODELS ONLY)
    • 5.10.1 Display Mode
  • 5.11 CONFIGURATION EDITING COMMANDS
  • 5.12 CUSTOM DEFAULT CONFIGURATION
  • 5.13 CODE TYPE RECOGNITION
  • 5.14 CONFIGURATION COPYING COMMANDS
    • 5.14.1 Copy PowerScan( D8330 Series
    • 5.14.2 Copy PowerScan( M8300 Series
    • 5.14.3 Copy BC-80X0
  • 5.15 DEFAULT PARAMETERS FOR POS TERMINALS
  • 5.16 FIRMWARE UPGRADE
• 6 MESSAGE FORMATTING
  • 6.1 MESSAGES FROM HOST TO READER
    • 6.1.1 Cursor Control
    • 6.1.2 Font Selection
    • 6.1.3 Clearing Display
    • 6.1.4 LED and Beeper Control
    • 6.1.5 Setting RTC
  • 6.2 MESSAGES FROM SCANNER COMMAND KEYS
• 7 TECHNICAL FEATURES
  • 7.1 POWERSCAN® D8330
  • 7.2 POWERSCAN® M8300
  • 7.3 BC-80X0 / C-8000
  • 7.4 SYSTEM AND RADIO FEATURES
  • 7.5 STATUS INDICATORS
  • 7.6 READING DIAGRAMS
• Copertina_BC.pdf
  • Page 1
• Copertina_FC.pdf
  • Page 1