Scanning features, Scan mode – Rice Lake Datalogic QuickScan QD2100 Linear Imager Hand-held Scanner User Manual
Page 37
Scanning Features
Product Reference Guide
29
Scanning Features
Scan Mode
Selects the scan operating mode for the reader. Selections are:
Trigger Single —
When the trigger is pulled, scanning is activated until one of the fol-
lowing occurs:
-
has elapsed
- a label has been read
- the trigger is released
This mode is associated with typical handheld reader operation: when the trigger is
pulled, scanning starts and the product scans until the trigger is released, or a label is read,
or the maximum
Trigger Hold Multiple —
When the trigger is pulled, scanning starts and the product
scans until the trigger is released or
has elapsed. Reading a label does
not disable scanning.
prevents undesired multiple reads of the same
label while in this mode.
Trigger Pulse Multiple —
When the trigger is pulled, continuous scanning is activated
until
has elapsed or the trigger has been released and pulled again.
prevents undesired multiple reads of the same label while in this
mode.
Flashing —
The reader flashes
1
on and off regardless of the trigger status. Flash rate is
. When Flash is ON the imager reads con-
tinuously. When Flash is OFF scanning is deactivated.
Always On —
No trigger pull is required to read a barcode. Scanning is continually on.
If the trigger is pulled, the reader acts as if it is in
prevents undesired multiple reads of the same label while in this mode.
Stand Mode —
No trigger pull is required to read a barcode. Scanning is turned on au-
tomatically when an item is placed in reader’s field of view. If the trigger is pulled, the
reader acts as if it in single read mode.
reads of the same label while in this mode.
Trigger Object Sense —
This mode is similar to Stand Mode, except that a trigger pull
is required to activate the decoder.
.