Rice Lake Datalogic QuickScan QD2100 Linear Imager Hand-held Scanner - Manual (Page 52)

RS-232 ONLY Interface
44 QuickScan® QD2100
Stop Bits
The stop bit(s) at the end of each transmitted character marks the end of transmission of
one character and prepares the receiving device for the next character in the serial data
stream. The number of stop bits selected (one or two) depends on the number the receiv-
ing terminal is programmed to accommodate. Set the number of stop bits to match host
device requirements.
ENTER/EXIT PROGRAMMING MODE
1 Stop Bit
2 Stop Bits
DEFAULT