2. installing the label roll holder – Rice Lake GoDEX DT4 User Manual User Manual
Page 11
Advertising
DT2 / DT4 User Manual
9
2-2. Installing the label roll holder
1.
Pull the label roll
holder out as far as
it will go.
2.
Fold out the label
supply hub as
shown in the
illustration.
3.
Now rotate the
label roll holder to
return the label
supply hub to its
original position.
Press down the
label supply hub
until it clicks into
place.
A.
To load label stock
with a 1" core, the
locking notch must
be at the top of the
label supply hub.
B.
To load label stock
with a 1.5" core, the
locking notch must
be at the bottom of
the label supply
hub.
【
Note
】
The hub is also marked
on both sides to indicate
the core size, as shown
in the illustration.
1" core
1.5" core
Advertising
This manual is related to the following products: