Rice Lake GoDEX DT4 User Manual User Manual
Page 28
Advertising
DT2 / DT4 User Manual
26
10. Open the dispenser by
folding it out.
11. Load the labels, following
the instructions in Section
2-1.
12. Remove the first label and
pass the label liner over
the roller and the tear-off
plate.
【
Note
】
The label stock should be at
least 25 mm high.
【
Suggestion
】
When using the label dispenser,
set the stop position to 9 mm
(DT2: 8 mm).
13. Pass the label liner
through the printer and
dispenser as shown in the
illustration.
14. Fold up the dispenser
cover to close it.
15. Switch on the printer and
press the FEED button to
measure the label stock.
Advertising
This manual is related to the following products: