Rice Lake GoDEX DT4 User Manual - Manual (Page 30)

DT2 / DT4 User Manual
28
DT4 DT2
5.
Turn the
printer upside
down and
tighten the
screws to
secure the
cutter.
5.
Turn the
printer upside
down and
remove the
screw that
secures the
cover on the
bottom of the
printer.
6.
Open the
cover on the
bottom of the
printer to
access the
motherboard.
6.
Tighten the
screws to
secure the
label cutter.
7. Connect the cutter to the
motherboard.
【 Note 】
Please make sure that you are
using the correct connector.
8. Close the cover on the
bottom of the printer (DT2:
and secure it with the
screw).
9.
Place the printer the right
way up again. In the next
step, load the label stock.