Accessories, 1. installing the label dispenser – Rice Lake GoDEX DT4 User Manual User Manual
Page 26
Advertising
DT2 / DT4 User Manual
24
5. Accessories
5-1. Installing the label dispenser
1
Label dispenser
2
1
2
Screws (set of 2)
【
Note1
】
Remember to switch
off the printer before installing
the label dispenser.
【
Note 2
】
A label liner
thickness of 0.006 mm ± 10%
and a weight of 65 g/m
2
± 6%
are recommended.
【
Note3
】
The label dispenser
will take labels up to a max.
width of 110 mm (DT4) or 54
mm (DT2).
1.
Place the printer on a flat
surface and open the
printer cover.
2.
Remove the front cover.
【
Note
】
You can use a coin or
screwdriver to open the cover.
3.
Pass the dispenser cable
through the opening as
shown in the illustration.
4.
Fit the label dispenser in
the recess provided.
Advertising
This manual is related to the following products: