Rice Lake Intercomp SW™ Deluxe Portable Vehicle Scale - Manual (Page 12)

SW Users
Rev G, February, 2000
12
Target Weights and Registers
The target weights represent the four weights that you want the actual wheel weights to
be at. The SW Scale is capable of storing 127 sets of target weights with an additional
10 character label ID. These stored target weights are retained even when the units is
turned off.
Select Register
Each register has the following information:
Ten character label ID.
LF target weight
RF target weight
LR target weight
RR target weight
When the scale is turned on it defaults to register 1. To select a different
register press SELECT REGIST, then enter the new register's number. When a
register is used for the first time or the data in it has be corrupted, the message
"Register Empty" will momentarily flash on the screen and the register will be
reset. The valid register numbers are 1 to 127.
Set ID
To set the 10 character label ID for a register you must first select that register
than press SET ID. The current ID will appear on the screen with the left most
character flashing. Use the arrow keys to change the ID and when finished
press ENTER.
Left arrow: Move the cursor one place to the left.
Right arrow: Move the cursor one place to the right.
Up arrow: Increase the flashing character (i.e. an A to a B).
Down arrow: Decrease the flashing character (i.e. a B to an A).
Set Target WGT
There are three methods under SET TARGET WGT for setting the target
weights:
1: Current actual
2: Wedge
3: Key in
From the SET TARGET WGT menu press 1 through 3 given your choice.