Rice Lake Intercomp SW™ Deluxe Portable Vehicle Scale - Manual (Page 7)

SW Users
Rev G, February, 2000
7
Quick Start
Setup the scales as described in SETUP on previous page. Turn the scales 'on'; after
a copyright screen you will see a display screen with five weights and a percentage.
The four weights that are on the left are the individual wheel weights. The weight in the
upper right is the total selected weight. The percentage is the percentage of selected
weight to total weight. You can switch to display the percentage of each pad by
pressing SHOW AS % and go back to the weights by pressing SHOW AS WGT. The
weights and percentages are displayed in the same pattern as a car left front, right
front, left rear, right rear. You can select or deselect a pad by pressing the LF, RF, LR,
RR (left front, right front, left rear, right rear); each time you press the button a select
arrow will turn on and off to the right of that pads weight. The T (or total) display line
shows the total weight on all four pads, and the percentage shown is the percentage of
selected weight to the total weight.
Optional External Printer
Press the on/off rocker switch to the right to turn the printer 'on', and to the left to turn it
off.
If the on/off switch is held down to the right when the printer is turned on the printer will
do a self print test. After the printer is 'on' holding the switch to the right will feed the
paper through the printer.
To load paper in the printer, insert the paper into the metal slot at the back of the
printer as far as it will go, then hold the on/off switch to the right to feed the paper.