0 scale assembly, 1 unpacking your scale, 2 repacking – Rice Lake Legal For Trade Platform/Fitness Scale - Rice Lake Dietary Fitness Scale Technical and Operating Instructions User Manual

Page 6: 3 setting up your scale

Advertising
background image

2

Dietary/Fitness Technical and Operating Instructions

2.0

Scale Assembly

2.1

Unpacking Your Scale

Place the unopened box in an open area that has ample room for unpacking the scale.
Parts contained in the shipping box include:

The scale

This manual

The indicator

AC adaptor (located in white box)

2.2

Repacking

If the Dietary Fitness Scale must be returned for modification, calibration or repair, it must be properly packed

with sufficient packing materials. Whenever possible, use the original carton for shipping the scale back.

NOTE: Damage caused by improper packaging is not covered by the warranty.

2.3

Setting Up Your Scale

Use the following steps to set up the Rice Lake Dietary Fitness Scale.

1. Remove the scale out of the packaging material that it came in and move it into the area where the

weighing process will occur.

2. To check for scale alignment, put the scale on a flat surface and look at the round spirit level on the base

of the scale. The scale is aligned when the air bubble is immediately in the center of the circle. If the air

bubble is not centered, unscrew and adjust the scale legs until the air bubble is centered. It’s

recommended to place the scale on a hard, level surface for the most accurate weighments. Thin

carpeting is fine but not recommended.

AC Power Connections

The Rice Lake Dietary Fitness Scale has a 120 VAC adaptor or 230 VAC adaptor to use when power is readily

available. The AC power adaptor plugs into the back of the indicator as shown in Figure 2-1.

L E D i n d i c a t o r l i g h t
illuminates from red to
green when charged.

Connect the AC power
source here.

R S - 2 3 2 P o r t
connection

S t o re t h e 2 3 0 VA C
adaptor here when not
in use

S t o r e t h e 1 2 0 VA C
adaptor here when not
in use

Back cover to indicator

Figure 2-1. LED Light Location

The AC adaptor, when not in use, plugs into the back housing of the indicator. Figure 2-1 shows that location.

Advertising